Owner's manual

B-8 PROFIBUS Communications Module
Sets the format used when performing explicit messages:
• Par Prot (Parameter Protocol) is used to read or write single
parameters.
• DPI Par Prot is reserved for future use.
Performing explicit messaging requires the “Parameter Access”
module to be added when configuring the node with a network
software tool.
Displays the state of the PROFIBUS controller.
23 Parameter Mode
Range: 0 = Par Prot
1 = DPI Par Prot
Default: 0 = Par Prot
Type: Read/Write
Reset Required: No
24 P-DP State
Range: 0 = WAIT_PRM
1 = WAIT_CFG
2 = DATA_EX
3= ERROR
Default: N/A
Type: Read Only
Reset Required: N/A