User guide

Interbus Module Parameters

B-5

I/O that the module is actively transmitting. The value of this

parameter will usually be equal to the value of DPI I/O Config (8).

Sets the Logic Command data that is sent to the drive if the

following is true:

• Comm Flt Action (6) is set to Send Flt Cfg and communications

are disrupted.

• Idle Flt Action (7) is set to Send Flt Cfg and the scanner is put into

Program or Test mode.

The bit definitions will depend on the product to which the module is

connected.

9 DPI I/O Active

Range:

See figure B.2.

Default:

See figure B.2.

Type:

Read Only

Reset Required:

N/A

Figure B.2 – DPI I/O Active (9)

00010xxx

01234567

1= I/O Enabled

0= I/O Disabled

x =Not Used

Cmd/Ref

Datalink A

Datalink B

Datalink C

Datalink D

Not Used

10 Flt Cfg Logic

Range:

0000 0000 0000 0000 to 1111 1111 1111 1111

Default:

0000 0000 0000 0000

Type:

Read/Write

Reset Required: