Owner manual

7-12

ControlNet Communications Module

Step 17. An Attention symbol is located next to the Node 2

(SP600_02) icon in figure 7.17, which indicates the

ControlNet scanner needs to be configured.

Step 18. Start RSNetWorx and perform the following:

a. Click the On-line icon and browse the network.

b. Select Edits Enabled and view the messages in the

Message View for completion (figure 7.18). The

con should disappear from the nodes in the Graphical

View.

c. Select

ile / Save

and save the project (figure 7.19).

d. Close RSNetworx.

This schedules the I/O that was configured in

RLSLogix 5000.

Figure 7.17 – RSLogix: Attention Symbol

RSLogix 5000 - Example_RECOMM-CNET [1756-L1]

Controller Example - RECOMM-CNET

SP600_02

RE: