Owner manual

6-16
ControlNet Communications Module
Set Attributes Scattered Example request and response Data:
Request Data
Response Data
A Get Attribute Single message is used to read a single parameter
(figure 6.11).
•
A Service Code of “E” indicates the Get_Attribute_Single service
(see page C-20, Common Services).
•
An Instance Number of “1” indicates Drive Parameter 1 will be
accessed (see page C-16, Instances).
•
An Attribute Number of “9” indicates the Parameter Value
Attribute will be accessed (see page C-17, Instance Attributes).
N13:0 45 Parameter Number = 45
N13:1 50 Value = 0.50HP
N13:2 0 (Pad Word)
N13:3 44 Parameter Number = 44
N13:4 1740 Value = 1740RPM
N13:5 0 (Pad Word)
N13:6 43 Parameter Number = 43
N13:7 600 Value = 60.0Hz
N13:8 0 (Pad Word)
N13:9 42 Parameter Number = 42
N13:10 16 Value = 1.6Amps
N13:11 0 (Pad Word)
N14:0 45 Parameter Number = 45
N14:1 0 (Pad Word)
N14:2 0 (Pad Word)
N14:3 44 Parameter Number = 44
N14:4 0 (Pad Word)
N14:5 0 (Pad Word)
N14:6 43 Parameter Number = 43
N14:7 0 (Pad Word)
N14:8 0 (Pad Word)
N14:9 42 Parameter Number = 42
N14:10 0 (Pad Word)
N14:11 0 (Pad Word)