Owner manual

Troubleshooting the ControlNet Module and Network
8-10
31 PCCC IO Open The peripheral has begun receiving PCCC
Control messages (the PCCC Control Timeout
was previously set to a non-zero value).
32 PCCC IO Time Flt The peripheral has not received a PCCC
Control Message for longer than the PCCC
Control Timeout.
33 Watchdog T/O Flt The software watchdog detects a failure.
34 EEPROM Init Start-up sequence detected a blank EEPROM
map revision. Intended to happen in factory
test.
35 DPI Fault Clear The user cleared a fault in the Host.
36 Normal Startup Peripheral completes a normal start up.
37 Manual Reset The user reset the module.
Table 8.6 – Event Codes and Descriptions
Code Event Description