User guide

Contents III
List of Figures
Figure 2.1 – Components of the RS485 DF1 Module................................. 2-1
Figure 3.1 – Setting the Module’s Node Address ....................................... 3-2
Figure 3.2 – Setting the Data Rate ............................................................. 3-2
Figure 3.3 – DPI Ports and Internal Interface Cables................................. 3-4
Figure 3.4 – Mounting the Module.............................................................. 3-5
Figure 3.5 – Typical Network Connections ................................................. 3-6
Figure 4.1 – Accessing the Module Parameters using the LCD OIM ......... 4-2
Figure 4.2 – RS485 DF1 Node Address Screen on an LCD OIM............... 4-2
Figure 4.3 – Data Rate Screen on an LCD OIM ......................................... 4-3
Figure 4.4 – Error-Checking Method Screen on an LCD OIM .................... 4-3
Figure 4.5 – I/O Configuration Screen on an LCD OIM .............................. 4-4
Figure 4.6 – Fault Action Screen on an LCD OIM ...................................... 4-5
Figure 4.7 – Reset Screen on an LCD OIM................................................ 4-7
Figure 5.1 – Typical RS485 DF1 Network .................................................. 5-1
Figure 5.2 – Connecting to the Network ..................................................... 5-1
Figure 5.3 – Node Selection Screen: Multiple Nodes Selected .................. 5-2
Figure 5.4 – Results of Search of Selected Nodes..................................... 5-2
Figure 5.5 – Result of Device Read Performed by VS Utilities................... 5-3
Figure 5.6 – Expanding Each Node............................................................ 5-3
Figure 5.7 – Accessing the Parameters in the Selected Device................. 5-4
Figure 6.1 – Status Indicators (Location on Drive May Vary) ..................... 6-1
Figure 6.2 – Viewing and Clearing Events Using an LCD OIM................... 6-7