User manual

Publication 1760-UM001A-EN-P
Saving and Loading Circuit Diagrams 5-3
Loading or Storing Programs
You can only transfer programs in Stop mode.
To transfer a program:
1.
1.1.
1. Switch to Stop mode.
2.
2.2.
2. Select “PROGRAM...” from the main menu.
3.
3.3.
3. Select the “CARD...” menu option.
The “CARD...” menu option only appears if you have
inserted a functional memory module.
You can transfer a program from Pico to the module,
from the memory module to Pico, or delete the content
of the memory module.
After completing the operation, remove the memory module and close the cover.
Storing a Circuit Diagram to the Memory Module
1.
1.1.
1. Select “DEVICE-> CARD”.
2.
2.2.
2. Confirm the prompt by pressing Ok. This deletes
the contents of the memory module and replaces it
with the program in Pico.
3.
3.3.
3. Press Esc to cancel.
NOTE
The no-display model, 1760-L12AWA-ND, can be loaded with a
program automatically from the memory module every time it is
powered up. Simply insert a memory module into the interface of
a 1760-L12AWA-ND and apply power to the controller. Pico
will automatically read the program from the memory module
and go into the RUN mode.
If the program in the memory module is not valid, the program
already in the Pico unit is retained.
IMPORTANT
If the power fails during communication with the memory
module, repeat the last procedure since Pico may not have
transferred or deleted all the data.
PROGRAM
DELETE PROG
CARD...
>
DEVICE - CARD
>
CARD - DEVICE
DELETE CARD
REPLACE ?