User manual

Publication 1760-UM001A-EN-P
4-36 Drawing a Circuit Diagram with Pico
The following applies to D1:
D1 is designed as an alarm text and takes precedence over all other text displays. If
D1 is activated, the text assigned to it is displayed until:
• The coil D1 is reset to 0
• Stop mode is selected
• The Pico power supply is switched off
• The Ok or Del + Alt buttons are used to switch to a menu
Text Entry
Text entry is only possible using PicoSoft version 2.1 and higher.
Character Set
All ASCII characters in upper and lower case are allowed.
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r s t u v w x y z
The following special characters are also allowed:
! “” # $% &’ ( ) * +, –. / 0 1 2 3 4 5 6 7 8 9
Examples
QUANTITY
QTY. 0042
SETP0500
!COUNTING!
HEAT DELAY
62.15 SEC
120.00 SEC
PRESET
FUSE
FAULT
HOUSE 1
FAILED!
Counter with actual value
and setpoint
Timer with actual value and
setpoint
D1 as error message on
fuse failure