User manual

Publication 1760-UM001A-EN-P
4-18 Drawing a Circuit Diagram with Pico
1.
1.1.
1. Enter the circuit diagram up to “C1” in the third
circuit connection.
C1 is the contact of counter relay 1. If the cursor is
on the contact number, Pico will call up the
parameter display when you press Ok.
2. Move the cursor onto the 1 in C1 and press Ok.
The parameter set for the counter is displayed.
3. Change the counter setpoint to 10:
Use the left and right buttons to move the cursor onto
the tens digit.
Use the up and down buttons to modify the value of
the digit.
4. Press Ok to save the value and Esc to return to the circuit diagram. Pico has
specific parameter displays for function relays. The meaning of these
parameters is explained under each relay type.
5. Enter the circuit diagram up to contact “T1” of the
timing relay. Set the parameters for T1.
The timing relay works like a flasher/blink relay. The
Pico symbol for the flasher/blink relay is shown in the
screen to the right. It is set at the top left of the
parameter display.
• Complete the circuit diagram.
• Test the circuit diagram using the power flow display.
• Switch Pico to Run mode and return to the circuit diagram.
Each parameter set can be displayed using the power flow display for the
circuit diagram.
6. Move the cursor onto C1 and press Ok.
The parameter set for the counter is displayed with
actual and setpoint values.
7. Switch I5. The actual value changes.
The coil terminal CNT is activated for as long as you press
push-button S1. This is represented in the Pico parameter
display.
I5----------CC1
I6----------RC1
C1
0010
DIR
CNT
RES
C1
+
{
{
02.00
TRG
RES
T1
+
{
S
DIR
CNT
RES
C1
+
{
0010
{
0000
DIR
CNT
RES
C1
+
{
0010
{
0002