User manual

Publication 1760-UM001A-EN-P
10-2 DC Simulator
Installation Guidelines
Esc
Ok
Del
Alt
4
5
3
I8I7I6I5
I4I3I2I1
1
2
1760-L12BWB
1760-L12BWB-NC
3
D
E
Q1 Q2 Q3 Q4
A
B
C
F
Installation Procedure
1.
1.1.
1. Connect inputs.
2.
2.2.
2. Connect outputs.
3.
3.3.
3. Plug in connection cable
4.
4.4.
4. Connect power supply.
5.
5.5.
5. Plug in power supply unit.
Identifying Components
A.
A.A.
A. Digital Inputs
B.
B.B.
B. I7 and I8 Analog Inputs
C.
C.C.
C. Power Supply Unit
D.
D.D.
D. Connection Cable
E.
E.E.
E. Output LEDs
F.
F.F.
F. Jumper
IMPORTANT
Observe the following precautions when using the DC Simulator:
1.
1.1.
1. The jumper (F) on the circuit board must be in the RC (lower) position. The simulator will not
operate if the jumper is in the TC (upper) position.
2.
2.2.
2. When using the digital input switches for inputs I7 and/or I8, make certain that the
corresponding analog input potentiometers are fully rotated to the OFF (clockwise) position.
3.
3.3.
3. When using the analog input potentiometers (B) for inputs I7 and/or I8, be certain that the
corresponding digital input switches are in the OFF position.
Input Board
Output Board
ATTENTION
!
!!
!
Be sure that power is not applied when installing the input and output simulator boards. Follow the
installation procedure below.