Specifications

Publication 1760-SG001F-EN-P - May 2006
8 Pico and Pico GFX-70 Programmable Controllers
Select Keypad
Programming or
Programming Software
Pico controllers, with on-board keypad and LCD display, can be
programmed from the front keypad. Models without the keypad and
LCD display are programmed by using PicoSoft Pro programming
software or by installing a pre-programmed memory module.
Use the Keypad
The keypad is an option on the display unit which is shown on
page 17.
Each program rung may contain three input instructions and one
output instruction. The instruction set includes:
• Input instructions - examine-on and examine-off.
• Output instructions - output enable (OTE), set (latch), reset
(unlatch), and flip-flop (alternating on/off).
• Timer instructions - on-delay, off-delay, single pulse, flashing.
• Counter instructions-count up, count down.
• Real-time Clock instructions - turn on or off based on
time-of-day and day-of-week (models with real-time-clock only).
• Analog Compare instructions - greater than or less than a set
point or each other.
• Text Display instructions - display messages, timers, and
counters on the LCD display.
PicoSoft Pro Software
PicoSoft Pro software includes all the features you need to:
• create a project.
• wire up a circuit diagram.
• test a circuit diagram.
• transfer it.
• print it out.
The PicoSoft Pro application is a complete package. It enables you to
create the control software, assign parameters to the function blocks
used, configure the visualization interface (including customizing the
look with your own *.bmp graphic files), use all screens and button
functions, and configure the entire project including the
multi-processor systems.
The software also includes functions for simulating the control
program, documenting the project, and for establishing
communication between the PC and the controller.