Specifications
Publication 1760-SG001F-EN-P - May 2006
18 Pico and Pico GFX-70 Programmable Controllers
GFX Programming Cable (1760-CBL-PC02)
The programming cable is used to transfer data between the PC and
the processor when using PicoSoft Pro Software.
GFX 256K Memory Module (1760-MM3)
Information stored on the memory module is non-volatile. Use the
module to archive, transfer, and copy your circuit diagram. Each
memory module can store one GFX program. It stores the program,
visualization data, and all parameter settings of the circuit diagram.
Power Supply (1606-XLP30E)
This 24V dc power supply is sized to provide enough power for any
Pico-GFX 70 system. Line power can be 100 to 240V ac or 85 to 375V
dc.
1760-CBL-5M Point-to-point serial interface cable, 5 m (16.4 ft)
1760-CBL-INT01 Pico-link cable, 0.3 m (1 ft)
1760-CBL-INT03 Pico-link cable 0.8 m (2.6 ft)
1760-CBL-INT05 Pico-link cable 1.5 m (5 ft)
1760-CBL-INT300 Pico-link cable, non-terminated, 100 m (300 ft)
1760-CONN-RJ45 Connectors for Pico-link cable
1760-TERM1 Network termination resistor
1760-NDM Membrane protect display
1760-NDC Cover to protect display
1760-NMF Mounting feet
1492-N90 Screwdriver
1492-KWC Wire cutter
TIP
Controllers without a keypad and display
automatically transfer the circuit diagram from the
inserted memory card to the Processor when the
power supply is switched on. If the memory card
contains an invalid circuit diagram, GFX will keep
the circuit diagram still present on the device.
Table 7 Pico GFX-70 Selection