User manual

Publication 1760-UM001D-EN-P - September 2005
2-8 Installation
Connect the Serial Cable
1. Remove the interface cover.
2. Using a screwdriver, push on the terminal latch.
3. Insert each wire into its designated terminal on the interface
connector.
4. Replace the interface cover.
Plug the other end of the cable into the Pico controller or I/O module.
Wire Terminals
Required Tools
Slot-head screwdriver (width: 3.5 mm, torque: 0.57 to 0.79 Nm [5 to 7
in-lb])
X5
Cable Wire Color Code
green
X4 white
X3 yellow
X2 brown
X1 gray
1
X5
X4
X3
X2
X1
2
3
4
1760-RM cable