Configuration and Diagnostic Software Tool User Manual Owner manual
Table Of Contents
- Content
- 1. Introduction
- 2. Installation
- 3. Optical Interface
- 4. Configuration Tool for GuardShield Safe 2/Safe 4 Light Curtains
- 5. Configuration Tool for MSR42
- 5.1. Introduction
- 5.2. Starting MSR42 Configuration Tool
- 5.3. The menu bar
- 5.4. Main window
- 5.4.1. Tab “Design”
- 5.4.2. Tab “Diagnosis”
- 5.4.3. Tab “Application info”
- 5.4.4. Possible Configurations
- 5.4.5. Micro 400 Light Curtain
- 5.4.6. One Device (2 NC)
- 5.4.7. One or Two Device (OSSDs)
- 5.4.8. Safety override
- 5.4.9. Muting Micro 400
- 5.4.10. Muting other device (OSSDs)
- 5.4.11. Function “EDM” + “Start Release”
- 5.4.12. Function “Stop delay”
- 5.5. Download, Verify & Upload
- 5.6. Muting
- 5.6.1. General
- 5.6.2. Muting lamp
- 5.6.3. Muting sensors
- 5.6.4. Mute dependant override function
- 5.6.5. Sensor output delay function
- 5.6.6. Muting with enable signal
- 5.6.7. Muting disable function
- 5.6.8. Safety light curtain interruption monitoring function
- 5.6.9. 43BMuting time recorder
- 5.6.10. 44BSetup: 2 sensor T-type
- 5.6.11. Setup: four sensor T-type
- 5.6.12. Setup: two sensor L-type
- 5.6.13. Setup: two sensor T-type with enable signal
- 5.7. Blanking
- 6. Appendix
9
Light Curtain Multi-Function Control Module User Manual
Original instructions
The connection is simple and completed in seconds:
• Plug the USB connector into an unused USB-port on your computer.
• Press the suction cup of the sensor head onto the marked position. For a more secure connection, the suction cup may be dampened slightly.
• Interrupt the light curtain (if connected). The communication between the Rockwell device and your computer will be initiated.
4. Configuration Tool for GuardShield Safe 2/Safe 4 Light Curtains
4.1. Introduction
Select the “GuardShield Safe 2/Safe 4” light curtain icon in the selection window (Figure 9). A new window will appear (Figure 11) with a “warning:
read safety information” symbol. Click on this symbol and read the safety warning. Thereafter click “OK” to continue.
Figure 11: GuardShield Safe 2/Safe 4 welcome screen
The “system designer” tab for Safe 2/Safe 4 screen will allow the user to select the light curtain to be used in the application.
Figure 12: “System Designer”
Input base