User guide

22 Rockwell Automation Publication MP-UM001D-EN-P - September 2013
Chapter 2 Understanding Your Linear Stage
Maintenance Intervals
This section lists typical maintenance intervals for your linear stage, and
references the section where maintenance procedures are described.
Lubrication Intervals
Refer to the Chapter 7 for lubrication procedures. The following lubrication
intervals are recommended.
• Direct drive linear stages every 6 months or 5000 km of travel
• Ball screw linear stages every 3 months or 150,000,000 revolutions
Cable Carrier Replacement
The cable carrier module’s useful lifetime is approximately 10,000,000 cycles.
Refer to the Chapter 8
for removal and replacement procedures.