User Manual

20 MP-Series Electric Cylinders
Rockwell Automation Publication MPAR-IN001D-EN-P - September 2012
Mating Cables
Commissioning
This section provides guidelines for using RSLogix™ 5000 software to configure your
electric-cylinder servo drive system.
Required Files
Firmware revisions and software versions required to support the electric cylinders include the
following:
• Kinetix 2000 or Kinetix 6000 multi-axis drives
– RSLogix 5000 software, version 16.00 or later
– Firmware revision 1.96 or later
– For RSLogix 5000 software, version 16.xx,
use Motion Database file, version 4_23_0 or later
– For RSLogix 5000 software, version 17.xx or later,
use Motion Database file, version 5_15_0 or later
• Kinetix 6200 multi-axis drives
– Firmware revision 1.30 or later
– For RSLogix 5000 software, version 17.xx,
use MPAR_5_19_11.cmf or later
• Kinetix 6500 multi-axis drives
– Firmware revision 1.11 or later
– For RSLogix 5000 software, version 18.xx,
use MPAR_5_19_11.cmf or later
• Kinetix 300 single-axis drives
– For RSLogix 5000 software, version 17.xx or later
Connector Cable Type Cable Cat. No.
Feedback Premolded 2090-CFBM7DD-CEAAxx (standard) or
2090-CFBM7DD-CEAFxx (continuous-flex)
Flying lead 2090-CFBM7DF-CEAAxx (standard) or
2090-CFBM7DF-CEAFxx (continuous-flex)
Power With brake wires 2090-CPBM7DF-xxAAxx (standard) or
2090-CPBM7DF-xxAFxx (continuous-flex)
Without brake wires 2090-CPWM7DF-xxAAxx (standard) or
2090-CPWM7DF-xxAFxx (continuous-flex)