User Manual

Rockwell Automation Publication CC-QS033A-EN-P - February 2014 41
System Validation Chapter 2
Download Your Program to the Controller
Follow these steps to download your program to your controller.
1. Connect an available USB port on your personal computer to the USB programming port on your Micro800
controller by using a USB A-to-B cable.
2. Build your program.
If you are prompted to install drivers, specify to use the recommended drivers.
3. From your Connected Components Workbench project, right-click on your device icon.
4. From the Project Organizer, choose Build.
When the program is done building, the Output pane at the bottom of your project window displays a build success
message.
5. If there are errors, fix your program errors, and build the program again.