User Manual

Rockwell Automation Publication CC-QS033A-EN-P - February 2014 31
Chapter 2
System Validation
In this chapter, you confirm the following:
• Communication between controller and PanelView Component terminal
• Controller generates the appropriate pulse output to control the motor
• Communication between controller and Kinetix 3 servo drive
The operation of the sample code and screens is also explained.
Before You Begin
• Review all steps in Chapter 1.
• Verify that all of the devices are connected as shown in the wiring diagram.
• Verify that the Micro800 controller, the Kinetix 3 drive, and the PanelView Component terminal have power
applied to them.
• Review the Getting Started CCAT with System Design Assistant Quick Start, publication CC-QS035.
What You Need
• Personal computer with Connected Components Workbench software version 6 or later installed
• 6 in. (or larger) PanelView Component terminal and 1761-CBL-PM02 communication cable
• Kinetix 3 drive and 2080-CCMDSDS-48AA01 communication cable
• Micro830 or Micro850, transistor-type output controller with 2080-SERIALISOL module
• USB printer cable (A to B) for personal computer to Micro800 controller communication