Software Owner manual

46 Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 1 Welcome to Motion Analyzer Software
1.2.2.4.3. Power Supply/Accessories - Single-axis Drive Systems
If your drive family is single axis, for example, Kinetix 300, Kinetix 350,
Kinetix 3, or Ultra™3000, Ultra5000, and Ultra1500, you must configure a shunt
or specify no shunt required.
Figure 34 - Power Supply/Accessories Dialog Box
Table 27 - Power Supply/Accessories Tabs (refer to Figure 34
)
Parameters Description Page
Power Data Tab View the regeneration and motoring data for each axis. 47
Shunt Tab
Select the external shunt resistors for single-axis systems. 47
Analysis Tab
Analyze the drive module activity in terms of bus voltage and system current.
With this tab, you can also simulate changes to the system parameters.
48
Energy Tab
View input current values and energy savings estimates for each axis. 49
Configure Power Supply
BOM Tab
Configure the bill of materials (BOM) for the power supply after fully sizing
the application.
50