Software Owner manual

Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012 29
Welcome to Motion Analyzer Software Chapter 1
1.2.2.4. Power Supply/Accessories View
In Axis view, you matched a drive with your motor. However, if there are power
components needed for your application, you’ll select them in Power Supply/
Accessories view.
1.2.2.4.1. Power Supply/Accessories - Multi-axis Drive Systems
If your drive family is Kinetix 2000, Kinetix 6000, or Kinetix 6200/6500, you’ll
also need to configure the IAM module and select the appropriate power rail.
Figure 22 - Power Supply/Accessories Dialog Box
Table 15 - Power Supply/Accessories Tabs (refer to Figure 22
)
Parameters Description Page
Power Data Tab
View regeneration and motoring data for each axis. 30
IAM and Shunt Tab
Select drive modules and external shunt resistors for multi -axis systems. 31
IAM Control Power Tab
Displays total auxiliary input power, input VA, input current, and power
distribution across the axes. These are the installation ratings for the IAM
module.
32
Analysis Tab
Analyze the drive module activity in terms of bus voltage and system
current. With this tab, you can also simulate changes to the system
parameters.
33
Energy Tab
View Input Current values, System Power values, Shunt Power, and Energy
Savings Estimates.
34
Configure Power Supply
BOM Tab
Configure the bill of materials (BOM) for the power supply after fully sizing
the application.
35