Software Owner manual

272 Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 4 Just Quote
4.2. IPIM Power Supply/
Accessories View
Power Supply Accessories view of an IPIM module helps you select options for
hybrid and network lengths, hybrid coupler cables, and bulkhead adapters.
Figure 219 - IPIM Module Selection
Table 167 - Configure IPIM Module BOM Tab Descriptions
Figure 220 - Configure IPIM Module BOM Tab
Options Description
Step 1 (Figure 219) IPIM module IPIM module selected on the IPIM Module tab is displayed here.
Step 2 (Figure 219
) Hybrid cables Hybrid cable lengths selected on the Cable Lengths tab are displayed here.
Step 3 (Figure 219)Network cables
Network cables can be routed with the hybrid cables, so network cable lengths
should be the same as the hybrid cable. The IPIM-to-IDM1 cable must have a
straight connector to the IPIM module.
Step 4 (Figure 219) Hybrid coupler The hybrid coupler connects between two hybrid cables, to bypass an IDM unit.
Step 5 (Figure 220
)
Network
bulkhead adapter
Use the network bulkhead adapter for securing network cables as they pass
through the cabinet.