Software Owner manual

124 Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 2 Sizing Your System
3. Click Edit Profile to specify the motion profile that the mechanism will
move through.
This motion profile is placed at the output of the motor or gearbox shaft, if
a gearbox is included in the motion system. Refer to Define Your Profile
on
page 139
for more information.
Once you specify the motion profile for the axis, the SolidWorks
integration begins.
4. Click Launch SolidWorks Simulator to obtain force/torque results from
SolidWorks software.