User guide

Rockwell Automation Publication 2094-UM003A-EN-P - May 2012 63
Connecting the Kinetix 6000M System Chapter 5
Ethernet Cable Connections
This procedure assumes you have your ControlLogix or CompactLogix
EtherNet/IP module and Bulletin 2094 control modules mounted and are ready
to connect the Ethernet network cables.
The EtherNet/IP network is connected by using the PORT 1 and/or PORT 2
connectors. The IPIM module uses the EtherNet/IP network only for
configuring the Logix program. Refer to page 42
to locate the Ethernet
connector on your IPIM module.
Refer to the Figure 29
to locate the connector on your EtherNet/IP controller
module.
Figure 29 - ControlLogix and CompactLogix Ethernet Port Locations
1 (Front)
2 (Rear)
00:00:BC:2E:69:F6
ControlLogix Platform
1756-ENxT EtherNet/IP Module is Shown
ControlLogix Ethernet Ports
The 1756-EN2T modules have only one port,
1756-EN2TR and 1756-EN3TR modules have two.
Bottom Views
Front Views
CompactLogix 5370 L1, L2, and L3 Controllers
1769-L3xERM Controller is Shown
Port 1, Front
Port 2, Rear