Owner manual

B-6 PROFIBUS Communications Module

Sets the corresponding node addresses of the daisy-chained drives

when the module Mode Jumper (J2) is set for Multi-Drive operation.

Important: The settings for these parameters must match the

Comm Node Addr (parameter A104) settings in the

respective drives. Each setting must also be unique (no

duplicate node address).

Displays the state of the PROFIBUS controller.

Drv 0 Addr

Drv 1 Addr

Drv 2 Addr

Drv 3 Addr

Drv 4 Addr

Range: 1 - 125

Default: Drv 0 Addr = 1

Drv 1 Addr = 2

Drv 2 Addr = 3

Drv 3 Addr = 4

Drv 4 Addr = 5

Type: Read/Write

Reset Required: Ye s

24 P-DP State

Range: 0 = WAIT_PRM

1 = WAIT_CFG

2 = DATA_EX

3 = ERROR

Default: N/A

Type: Read Only

Reset Required: N/A