Owner's manual

29 Publication LZ-UM001A-EN-P - January 2008

Chapter

Hall Effect Module Removal and Replacement

Introduction

Use this section to change the Hall effect module.

Hall Effect Module

If a problem is detected with a Hall effect module use the following

procedures to remove and replace the unit.

The following procedures require a 3 mm hex key, non-magnetic preferred,

and cardboard to fit in magnet channel.

Replacement Hall Effect Modules

Remove the Hall Effect Module

1. Disconnect the Hall cable from the drive.

1. Place the cardboard in the magnet channel to prevent tools from

damaging the magnets by limiting the attractive forces.

2. Remove the two M4 SHCS using a 3 mm hex key.

Install the Hall Effect Module

1. Place the cardboard in the magnet channel to prevent tools from

damaging the magnets by limiting the attractive forces.

Topic Page

Hall Effect Module 29

Coil

Catalog No.

Winding

Typ e

Hall Effect Module

Part Number

LZ-xxx-x-xxx-D-x-x-xx-x Y B91860

LZ-xxx-x-xxx-E-x-x-xx-x

LZ-xxx-x-xxx-F-x-x-xx-x Delta B91860-Delta

LZ-xxx-x-xxx-G-x-x-xx-x