Quick Start Owner's manual
Table Of Contents
- 1756-QS001E-EN-P, Logix5000 Controllers Quick Start
- Summary of Changes
- Table of Contents
- 1 - Program and Test a Simple Project
- What You Need
- Before You Begin
- Follow These Steps
- Create a Project for the Controller
- Add Your I/O Modules
- Look at Your I/O Data
- Ladder Logic
- Enter a Function Block Diagram
- Assign Alias Tags for Your Devices
- Establish a Serial Connection to the Controller
- Download a Project to the Controller
- Select the Operating Mode of the Controller
- 2 - Organize a Project
- 3 - Program Add-On Instructions
- What You Need
- Follow These Steps
- Insert an Add-On Instruction
- Copy an Add-On Instruction Definition
- Import an Add-On Instruction Definition
- Access a Parameter That Is Not Visible
- Monitor or Change the Value of a Parameter of an Add-On Instruction
- View the Logic of an Add-On Instruction
- Edit and Monitor an Add-On Instruction
- Update an Add-On Instruction to a Newer Revision
- 4 - Program an Equipment Phase
- 5 - Program a Project Offline
- 6 - Document a Project
- 7 - Go Online to the Controller
- 8 - Program a Project Online
- 9 - Troubleshoot the Controller
- Index
- Back Cover
114 Publication 1756-QS001E-EN-P - October 2009
Chapter 7 Go Online to the Controller
5. Click the Port Configuration tab.
6. Depending on your device, either:
• Select the Static button.
• Clear (uncheck) the Obtain IP Address from BOOTP Server check box.
7. Type the:
• IP address.
• subnet mask.
• gateway address (if required).
8. Click OK and then click Yes.
Assign an IP Address to Your Computer
If your EtherNet/IP network is a standalone network and your EtherNet/IP device uses IP address and
subnet mask values, you may need to change the IP address and subnet mask values for your computer.
1. Choose Start > Settings > Network and Dial-up Connections.
2. Right-click on Local Area Connection.
3. Choose Properties.