User Manual
Table Of Contents
- Logix5000 Controllers I/O and Tag Data
- Summary of changes
- Table of contents
- Preface
- Communicate with I/O modules
- Organize tags
- Force I/O
- Data access control
- Introduction
- External access
- Configure external access
- External access availability
- User-defined type considerations
- Add-on instructions external access considerations
- Tag mapping considerations
- Imported tag behavior
- Constant value tags
- Configure constant tags
- Constant check box availability
- Add-on instructions constant value considerations
- Index
Chapter 2 Organize tags
3. Check Show Pass-Through Descriptions and Append to Base Tag
Descriptions.
4. Click OK.
Paste a pass-through description
Choose this command to paste a pass-through value of an item into the
Description, Engineering Unit, State 0, or State 1 field of another item.
Follow these steps to use a pass-through description as the starting point for a
more specific description.
1. In the Controller Tags Editor, right-click the Description box, and then
click Paste Pass-Through.
2. Edit the description and press CTRL+Enter.
46 Rockwell Automation Publication 1756-PM004E-EN-P - October 2014