User Manual
Table Of Contents
- Logix5000 Controllers I/O and Tag Data
- Summary of changes
- Table of contents
- Preface
- Communicate with I/O modules
- Organize tags
- Force I/O
- Data access control
- Introduction
- External access
- Configure external access
- External access availability
- User-defined type considerations
- Add-on instructions external access considerations
- Tag mapping considerations
- Imported tag behavior
- Constant value tags
- Configure constant tags
- Constant check box availability
- Add-on instructions constant value considerations
- Index
Organize tags Chapter 2
Paste pass-through description—Use the data type and array description as a basis for more specific
descriptions.
In this example, Tank became West Tank.
The Logix Designer application uses different colors for descriptions.
If the Color of the Description Is It is a
Gray Pass-through description
Black Manually entered description
Activate pass-through and append descriptions
Follow these steps to use pass-through descriptions and append to base tag
descriptions.
1. In the Controller Organizer, right-click the controller at the top and then
click Properties.
2. In the Controller Properties dialog box, click the Project tab.
Rock well Automati on Publication 1756- PM004E -EN-P - October 2014 45