Instruction Manual

©2000 Rockwell International Corporation
LiquiFlo is a trademark of Rockwell Automation.
Panel Mount Kit
for LiquiFlo AC Drives
M/N 120L4060
Model Number 120L4060PM
Instruction Manual D2-3467
Product Description
This instruction manual describes how to install an optional panel mount kit on D-frame LiquiFlo AC drives,
M/N 120L4060. The kit comprises items that make panel mounting of a LiquiFlo AC drive safer and easier.
Each kit includes bus bar jumpers, pressure lugs, coolant tube assemblies, and the necessary mounting
hardware.
Verifying Kit Contents
Panel mount kit M/N 120L4060PM can be used only with D-frame LiquiFlo AC drives, M/N 120L4060. Kit
contents are listed in table 1, and are indicated by circled item numbers in figure 1.
!
ATTENTION: Only qualified personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, and/or service this equipment.
Read and understand this instruction manual in its entirety before proceeding. Failure to observe
this precaution could result in severe bodily injury or loss of life.
Table 1 – Panel Mount Kit Contents
Item Description Qty
Part Number
1 Jumper Bus Bar 3 179437
2 Pressure Lug, 2-Conductor, 800 MCM - 300 MCM 6 179477
3Flat Washer, 3/8”, 1.25” O.D., Gr.5 6 601748-14A
4 Conical Washer, 3/8”, 1.00” O.D., Gr. 5 6 601748-7G
5 HHCS Screw, 3/8-16 UNC-2A x 1.50” Lg, Gr.5 6 601741-47E
6 Hex Nut, 1/2-13 UNC-2B, Gr. 5 3 179506
7 Flat Washer, 1/2” 12 103237
8 Conical Washer, 1/2”, 1.26” O.D., Gr. 5 9 601748-7H
9 Screw, HHCS, 1/2-13 UNC-2A x 2.00” Lg, Gr. 5 9 601741-48G
10 Inlet Tube Assembly 1 179414
11 Outlet Tube Assembly 1 179418
12 Gasket, 2 Bolt-Hole 2 179473
13 Split Ring Lock Washer, 5/16”, Gr. 2 4 601748-3K