Owner's manual
Table Of Contents
- Front Cover
- Important User Information
- Summary of Changes
- Table of Contents
- Introduction
- About the Drive
- Identifying the Drive by Cabinet Assembly ID Number
- LiquiFlo 2.0 Drive Component Locations
- Identifying the Power Module by Model Number
- AC Line I/O Board Description (Frame 3 Only)
- Standard I/O Board Description (Frame 3 Only)
- Combined I/O Board Description (Frame 4 Only)
- DPI Communication Ports
- Optional Equipment
- Planning the Installation
- Mounting The Power Module and Grounding the Drive
- Installing Input and Output Power Wiring
- Completing the Installation
- Using the Start-up Routines
- Programming Basics
- Parameter Descriptions
- Troubleshooting the Drive
- Verify that the DC Bus Capacitors are Discharged Before Servicing the Drive
- Determining Drive Status Using the Status LEDs
- About Alarms
- About Faults
- Diagnostic Parameters
- Common Symptoms and Corrective Actions
- Replacement Parts
- Board Replacement, Firmware Setup Procedures
- Troubleshooting the Drive Using the OIM
- Checking the Power Modules with Input Power Off
- Technical Specifications
- Using the OIM
- Installing and Removing the OIM
- Display Description
- OIM Menu Structure
- Powering Up and Adjusting the OIM
- Selecting a Device in the System
- Using the OIM to Program the Drive
- Monitoring the Drive Using the Process Display Screen on the OIM
- Displaying and Changing the OIM Reference
- Customizing the Process Display Screen
- Customizing the Function Keys
- Controlling the Drive From the OIM
- LiquiFlo 2.0 Drive Frame 3 Wiring Diagrams
- LiquiFlo 2.0 Drive Frame 4 Wiring Diagrams
- Index
- Back Cover
182 Rockwell Automation Publication D2-3518-3 - May 2013
Chapter 9
This parameter is not used in the Liquiflo 2.0 rectifier.
This parameter is not used in the Liquiflo 2.0 rectifier.
Reserved for future alarms.
Reserved for inhibit bits.
Displays status of the rectifier digital inputs.
See AC Line I/O Board Description (Frame 3 Only)
on page 25 through
Combined I/O Board Description (Frame 4 Only)
on page 29 for a description
of I/O hardware that is present on this drive and is controlled by the rectifier.
201 Language
Range: 0...10
Default: Read Only
Access: 0 Path: Utility > Drive Memory
See also:
203 Drive Checksum
Range: 0...65535
Default: Read Only
Access: 0 Path: Utility > Drive Memory
See also:
211 Drive Alarm
Range:
Default: Read Only
Access: 0 Path: Utility > Status
See also:
214 Start Inhibits
Range:
Default: Read Only
Access: 0 Path: Utility > Status
See also:
216 Dig In Status
Range: Bits on/off
Default: Read Only
Access: 0 Path: Utility > Status
See also: