Instructions Manual

Recommended Reach Drive Lifting Instructions

Instruction Manual D2-3564

REACH DRIVE UNIT WEIGHT = 44.5 kg (98.0 lbs.)

LOOP STRAP OVER HANDLE

CROSS-MEMBER AND UNDER

HANDLE AS SHOWN. TYPICAL

(4) PLACES

SEE STRAP DETAIL

STRAP DETAIL

ANGLEMUSTBE

LESS THAN 45°

Note: Sling capacity is typically derated to 70% with a 45 degree angle.

PAGE 1
Recommended Reach Drive Lifting Instructions Instruction Manual D2-3564 1 REACH DRIVE UNIT WEIGHT = 44.5 kg (98.0 lbs.) LOOP STRAP OVER HANDLE CROSS-MEMBER AND UNDER HANDLE AS SHOWN. TYPICAL(4) PLACES 2 SEE STRAP DETAIL STRAP DETAIL Note: Sling capacity is typically derated to 70% with a 45 degree angle. ©2006 Rockwell Automation. All rights reserved.
PAGE 2
USE HANDLES TO LIFT UNIT 3 DO NOT LIFT UNIT BY HOLES IN COLDPLATE DO NOT LIFT UNIT BY HOLES IN COOLANT PORT USE UNIT CUTOUTS FOR LIFTING DO NOT USE HOLES IN COLDPLATE FOR LIFTING 4 DO NOT USE HOLES IN COLDPLATE FOR LIFTING DO NOT USE HOLES IN COLDPLATE FOR LIFTING www.rockwellautomation.com Power, Control and Information Solutions Headquarters Americas: Rockwell Automation, 1201 South Second Street, Milwaukee, WI 53204-2496 USA, Tel: (1) 414.382.2000, Fax: (1) 414.382.
PAGE 3
PAGE 4
U.S. Drives Technical Support Tel: (1) 262.512.8176, Fax: (1) 262.512.2222, Email: support@drives.ra.rockwell.com, Online: www.ab.com/support/abdrives Trademarks not belonging to Rockwell Automation are property of their respective companies. Publication D2-3564- November 2006 Copyright © 2006 Rockwell Automation, Inc. All Rights Reserved. Printed in USA.