User Manual

Programming Reference 4-55

H.001 Motor Nameplate Base Frequency (continued)

The V/Hz ratio is affected by the selection of Volts/Hertz Curve Type in H.018 and the

setting of Torque Boost Voltage in H.003. See figure 4.10.

Figure 4.10 – Volts/Hz Ratio

Maximum

V/Hz

H.001

Minimum

V/Hz

Motor

Voltage,

H.000

(volts)

Output Frequency

(Hz)

100%

H.002 Motor Nameplate Amps

This parameter is the

motor amp rating as it

appears on the motor

nameplate.

Parameter Range: Power Module-dependent

Default Setting: Power Module-dependent, see Appendix C

Parameter Type: Configurable

Refer also to parameters: P.005 Current Limit

ATTENTION: This parameter must not exceed the rated amps found on

the motor nameplate. Excess heating of the motor could result if this is

not done. Failure to observe this precaution could result in damage to,

or destruction of, the equipment.