User Manual Instruction Manual

Installing Regulator Board Control Wiring 6-9
3-Wire Control
Internal Supply
No changes required.
3-Wire Control
External supply
(I/O Board
dependent).
Requires 3-wire
functions only
(Digital ln1 Sel).
Using 2-wire
selections will
cause a type 2
alarm
No changes required.
Digital Output
Relays (two at
terminals 14 and
16) shown in
powered state
with drive faulted.
Select source to activate:
Parameters 380 and 384.
Enable Input Configure with parameter 366. For
dedicated hardware enable, remove
jumper J10.
1.Important: Programming inputs for 2 wire control deactivates all OIM Start buttons.
Input/Output Connection Example Required Parameter Changes
Start
24
25
26
27
28
Stop
Start
25
27
28
Stop
115V/
+24V
Neutral/
Common
Power Source
11
12
13
14
15
16
Fault
NOT Fault
NOT Run
Run
or
32