User Manual Instruction Manual

Installing Regulator Board Control Wiring 6-7
6.5 I/O Wiring Examples
!
ATTENTION: When using bipolar analog inputs, unpredictable changes
in motor speed and direction can be caused by noise and drift in sensitive
circuits. Use speed command parameters to help reduce input source
sensitivity. Failure to observe this precaution could result in bodily injury
or damage to equipment.
Input/Output Connection Example Required Parameter Changes
Potentiometer
Unipolar Speed
Reference
10k Ohm Pot.
Recommended
(2k Ohm
Minimum)
Adjust Scaling: Parameters 91/92
and 325/326
View Results: Parameter 02
Joystick Bipolar
Speed
Reference
+/- 10V Input
Set Direction Mode: Parameter 190
set to 1 = Bipolar
Adjust Scaling: Parameters 91/92
and 325/326
View Results: Parameter 02
Analog Input
Bipolar Speed
Reference
+/- 10V Input
Set Direction Mode: Parameter 190
set to 1 = Bipolar
Adjust Scaling: Parameters 91/92
and 325/326
View Results: Parameter 02
Analog Voltage
Input Unipolar
Speed
Reference
0 to +10V Input
Configure input for Current:
Parameter 320 and add jumper at
appropriate terminals
Adjust Scaling: Parameters 91/92
and 325/326
View Results: Parameter 02
Analog Current
Input Unipolar
Speed
Reference
4-20 mA Input
Configure input for Current:
Parameter 320 and add jumper at
appropriate terminals
Adjust Scaling: Parameters 91/92
and 325/326
View Results: Parameter 02
3
4
5
22
3
5
21
22
3
4
Common
+
3
4
Common
+
3
4
19
20
Common
+