User Manual Instruction Manual

Index Index-5
Output Powr Fctr (8), 11-3
Output Voltage (6), 11-3
Overspeed Limit (83), 11-18
P
Param Access Lvl (196), 11-53
Parameter access level, 2-11
Parameters
cross-referenced by name, ?? to A-15, ?? to
A-15
types, 9-1
PCP, 11-116
PCP Pump Sheave (637), 11-116
Phase V Amps (23), 11-5, 11-20
PI BW Filter (139), 11-36
PI Configuration (124), 11-29
PI Control (125), 11-30
PI control, about, 11-31
PI Deriv Time (459), 11-108
PI Error Meter (137), 11-36
PI Fdback Meter (136), 11-36
PI Feedback Hi (462), 11-108
PI Feedback Lo (463), 11-108
PI Feedback Sel (128), 11-33
PI Integral Time (129), 11-33
PI Lower Limit (131), 11-34
PI Output Gain (464), 11-109
PI Output Meter (138), 11-36
PI Preload (133), 11-34
PI Prop Gain (130), 11-34
PI Ref Meter (135), 11-35
PI Reference Hi (460), 11-108
PI Reference Lo (461), 11-108
PI Reference Sel (126), 11-32
PI Setpoint (127), 11-32
PI Status (134), 11-35
PI Upper Limit (132), 11-34
Port, 11-143
Port Mask Actv (595), 11-143
Pos Reg Filter (718), 11-122
Pos Reg Gain (719), 11-123
Pos Torque Limit (436), 11-104
Power Enclosure Ratings, 2-2
Power Loss Level (186), 11-50
Power Loss Mode (184), 11-49
Power Loss Time (185), 11-50
Power Up Marker (242), 11-69
power wire sizes, 4-3
Powerup Delay (167), 11-44
Preset Frequency, 2-8
Preset Speed 1 (101), 11-25
Preset Speed 2 (102), 11-25
Preset Speed 3 (103), 11-25
Preset Speed 4 (104), 11-25
Preset Speed 5 (105), 11-25
Preset Speed 6 (106), 11-25
Preset Speed 7 (107), 11-25
Process PI Loop, 2-11
Profile, 11-120, 11-121
Profile Command (705), 11-121
Profile Status (700), 11-120
Programming basics, 9-1
PTC HW Value (18), 11-5
Pulse Input Ref (99), 11-25
Pulse ln Scale (422), 11-102
PWM, 11-135
PWM DAC Enable (513), 11-135
PWM Frequency (151), 11-39
PWM Type Select (524), 11-136
R
Ramped Speed (22), 11-5
Rated Amps (28), 11-6
Rated kW (26), 11-6
Rated Volts (27), 11-6
Rec Delay Time (538), 11-140
Regen Power Limit (153), 11-40
Replacement parts, 11-23
Reset Meters (200), 11-55
Reset To Defalts (197), 11-54
Rev Speed Limit (454), 11-107
Rod, 11-115
Rod Load Torque (631), 11-115
Run Boost (70), 11-15
S
S Curve % (146), 11-38
Save MOP Ref (194), 11-53
Save OIM Ref (192), 11-52
Save To User Set (199), 11-55
Scale1 ln Hi (477), 11-109
Scale1 ln Lo (478), 11-110
Scale1 ln Value (476), 11-109
Scale1Out Hi (479), 11-110
Scale1Out Lo (480), 11-110
Scale1Out Value (481), 11-111
Scale2 ln Hi (483), 11-109
Scale2 ln Lo (484), 11-110
Scale2 ln Value (482), 11-109
Scale2 Out Hi (485), 11-110
Scale2 Out Lo (486), 11-110