Manualshelf

User Manual Instruction Manual

ManualsBrandsRockwell Automation ManualsEquipmentGV6000 AC Drive
41424344454647484950
Mounting the Drive, Grounding, and Determining Wire Routing Locations
3-1
CHAPTER 3
Mounting the Drive, Grounding, and
Determining Wire Routing Locations
This chapter provides information that must be considered when planning a GV6000
AC drive installation and provides drive mounting information. Installation site
requirements, drive requirements, and wiring requirements are presented.
3.1 General Requirements for the Installation Site
It is important to properly plan before installing a GV6000 AC drive to ensure that the
drive’s environment and operating conditions are satisfactory.
Note that no devices are to be mounted behind the drive. If air-cooled devices are
mounted near the drive, the hot air exhaust may raise the ambient temperature level
above what is allowed for safe operation of the drive.
The area behind the drive must be kept clear of all control and power wiring. Power
connections may create electromagnetic fields that may interfere with control wiring or
components when run in close proximity to the drive.
Read the following recommendations before continuing with drive installation.
!
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should install, adjust, operate, or service this equipment. Read and
understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in
severe bodily injury or loss of life.
ATTENTION: Use of power correction capacitors on the output of the
drive can result in erratic operation of the motor, nuisance tripping, and/or
permanent damage to the drive. Remove power correction capacitors
before proceeding. Failure to observe this precaution could result in
damage to, or destruction of, the equipment.
ATTENTION: The user is responsible for conforming with all applicable
local, national, and international codes. Failure to observe this precaution
could result in damage to, or destruction of, the equipment.