User Manual Instruction Manual
About the Drive
2-13
2.3.27 Programmable Parameter Access Levels and Protection
The GV6000 drive allows you to limit the number of parameters that can be viewed on
the LCD OIM using an Access Level password. Param Access Lvl (196) is read-only
and shows the active access level (Basic, Standard, or Advanced). Each access level
can be password protected.
If you are trying to gain access to a particular parameter and the OIM skips over it, you
must change the parameter view from "Basic" to "Advanced." This can be
accomplished by reprogramming Param Access Lvl (196) to "Advanced"
You can also protect parameters from unauthorized changes by activating the Write
Protect password. See section 10.4 for more information about this password.
Writing of passwords can also be enabled/disabled on a port-by-port basis through
Write Mask Cfg (596).
2.3.28 User Sets
2.3.28.1Normal Mode
After a drive has been configured for a given application, you can store a copy of all of
the parameter settings in a specific EEPROM area known as a user set. Up to three
user sets can be stored in the driveās memory to be used for backup, batch switching,
or other needs. All parameter information is stored. You can then recall this data to the
active drive operating memory as needed. Each user set can also be identified with a
user-selected name.
You can use this feature using any of the following methods:
⢠Set parameters Load Frm Usr Set (198) and Save To User Set (199). Refer to the
parameter descriptions in chapter 11.
⢠Access the Memory Storage menu on the LCD OIM.
Figure 2.2 ā Normal Mode Operation