User Manual Instruction Manual

12-6 GV000 AC Drive User Manual
12.4.1 Alarm Descriptions
Table 12.4 – Alarm Descriptions
Alarm
No.
Type
Description
Analog In
Loss
5
➀
An analog input is configured for alarm on signal loss and signal
loss has occurred.
Bipolar
Conflict
20
➁
Parameter 190 (Direction Mode) is set to Bipolar or Reverse Dis and
one of more of the following digital input functions is configured:
Fwd/Rev, Run Fwd, Run Rev, Jog Fwd, or Jog Rev.
Brake
Slipped
32
➁
Encoder movement has exceeded the level in BrkSlipCount after
the brake was set.
Decel
Inhibit
10
➀
Drive is being inhibited from decelerating.
Dig In
ConflictA
17
➁
Digital input functions are in conflict. Combinations marked with a
will cause an alarm.
Dig In
ConflictB
18
➁
Digital input functions are in conflict. Combinations marked with a
will cause an alarm.
Dig In
ConflictC
19
➁
More than one physical input has been configured to the same input
function. Multiple configurations are not allowed for the following
input functions:
Acc2 /
Dec2
Accel 2 Decel 2 Jog Jog Fwd Jog Rev
Fwd /
Rev
Acc2 / Dec2
Accel 2
Decel 2
Jog
Jog Fwd
Jog Rev
Fwd / Rev
Start
Stop–
CF
Run
Run
Fwd
Run
Rev
Jog
Jog
Fwd
Jog
Rev
Fwd/
Rev
Start
Stop–CF
Run
Run Fwd
Run Rev
Jog
Jog Fwd
Jog Rev
Fwd / Rev
Forward/Reverse Run Reverse Bus Regulation Mode B
Speed Select 1 Jog Forward Acc2 / Dec2
Speed Select 2 Jog Reverse Accel 2
Speed Select 3 Run Decel 2
Run Forward Stop Mode B