User Manual Instruction Manual

Parameter Descriptions

11-111

Value of the signal being sent out of the Universal Scale Block. Typically this value is

used as the source of information and will be linked to another parameter.

Parameters 500 - 598 are found in the Advanced Tuning Parameters

Section (Section 11.2).

Enables/disables torque/brake proving feature. When Enabled, Digital Out1 Sel (380)

becomes the brake control.

This value is not changed when parameters are reset to factory defaults.

Enable = Enables Torque Proving features.

Encoderless = Enables encoderless operation - bit 0 must also be enabled.

MicroPosSel = A “1” allows the Micro Position digital input to change the speed

command while the drive is running.

Preload Sel = “0” uses the last torque for preload. “1” uses “TorqRef A” if commanded

direction is forward and “TorqRef B” for reverse.

481

487

493

499

Scale1 Out Value

Scale2 Out Value

Scale3 Out Value

Scale4 Out Value

Range: -/+ 32767.000 [0.001]

Default: Read Only

Access: 2 Path: Utility>Scaled Blocks