User Manual Instruction Manual

Parameter Descriptions 11-11
Enables/disables the compensation correction options.
Reflect Wave = Enables/disables reflected wave correction software, which reduces
overvoltage transients from the drive to the motor. For lead lengths beyond 300 feet,
enable this feature.
Figure 11.1 – Speed Limits
Frequency
Overspeed
Limit
(83)
Frequency Trim
due to Speed
Control Mode
Max Volts
(54)
Motor Volts
(41)
Run
Boost
(70)
Break Volts
(71)
Start Boost
(69)
Allowable Output Frequency Range - Normal Operation
Allowable Speed Reference Range
Allowable Output Frequency Range -
Bus Regulation or Current Limit
Maximum
Freq
(55)
Motor NP Hz
(43)
0 Break
Frequency
(72)
Max
Speed
(82)
Min
Speed
(81)
Output
Freq Limit
V
o
l
t
a
g
e
56 Compensation
Range: See figure 11.2
Default: See figure 11.2
Access: 2 Path: Motor Control>Torq Attributes
See also:
Figure 11.2 – Compensation (56)
101110 x 0 xxxxxxx
10 01234567891112131415
1 =Enabled
0 =Disabled
x =Reserved
Bit #
Factory Default Bit Values
(1)
For current limit (except FVC Vector mode).
Reflect W
ave
Enable Jerk
(1)
Ixo AutoCalc
Xsistor Diag
Rs Adapt
Mtr Lead Rev
PWM FreqLock
TPEncdless
0