User Manual Instruction Manual

Programming Basics 10-5
10.3.2 Using the Parameter Access Level Password to Restrict Access to
Other Parameter Levels
The LCD OIM provides the option to restrict access to other parameter levels. This
feature requires the use of a user-defined password when an attempt to change the
access level is made.
To set the access level password, select the Password tab from the main menu. See
figure 10.4. The password value can range from 1 to 9999. A value of 0 disables the
password (factory default). You must either select Logout or return to the process
display screen to activate the password.
When you enter the password, you can change access levels until you return to the
process display screen, which re-activates the password.
Note that once the password is enabled, you will also be prompted to enter the
password to access the Set Acc Lvl PW option.
This option is not supported in the V*S Utilities software.
If There is More Than One OIM Connected to the Drive
Note that setting or changing the access level password on one OIM will set or change
the access level password for all OIMs connected to the drive.
!
ATTENTION:It is the user’s responsibility to determine how to distribute
the access level password. Reliance Electric is not responsible for
unauthorized access violations within the user’s organization. Failure to
observe this precaution could result in bodily injury.
Figure 10.4 – Setting the Access Level Password
Password
SEL
Display Memory Psswrd
Set Access Level
Set WrtProt Password
Set AccLvl Password
Password
SEL
Display Memory Psswrd
Set Access Level
Set WrtProt Password
Set AccLvl PasswordAccess Level
Enter new
Password
0