User Manual Instruction Manual

Programming Basics 10-3
10.3 Accessing the Parameters
Parameters are programmed and viewed using the LCD OIM or V*S Utilities/V*S
Utilities Pro.
The LCD OIM displays parameters by group, by individual parameter number, and by
parameters that have changed from their default value.
To access parameters using the LCD OIM, select the parameters tab from the main
screen. See figure 10.2.
See Chapter 8 for information on modifying parameters using the LCD OIM.
See instruction manual D2-3488 for information on accessing and modifying
parameters using V*S Utilities software.
Figure 10.2 – Accessing the Parameters Using the LCD OIM
Speed Command
Spd Mode & Limts
Control Src Sel
Speed References
Parameters
Linear Param List
SEL
PARAM DIAGSTARTUP
Parameters by Group
Changed Parameters
MOTOR
CONTROL
SPEED
COMMAND
MONITOR
SEL
Parameters
SEL
PARAM DIAGSTARTUP
Parameters by Group
Changed Parameters
Linear Param List
Output Frequency
SEL
LIMITS HELPVALUE
Parameter: # 001
HZ
58.3
Parameters
SEL
PARAM DIAGSTARTUP
Parameters by Group
Linear Param List
Changed Parameters
Logic Source Sel
SEL
LIMITS HELPVALUE
Parameter: # 089
Terminal Blk 0