User Manual Instruction Manual

Starting Up the Drive Using the LCD OIM 9-7
example below shows speed reference from an analog voltage input. Analog inputs
can also be configured for 4 to 20 mA.
See chapter 6 for more information about terminal block references.
Note: This example assumes Speed Units (79) is set to “Hz”.
Figure 9.2 – Analog Speed Reference
2225
A
nalog In 1 (-
)
Common
+10
VDC
Analog
I
n 1
(
+)
1
Analog Reference Wiring (Voltage)
(90) Speed Ref A Sel = Analog In1
(91) Speed Ref Hi = 60 Hz
(92) Speed Ref Lo = 0 Hz
(P320) Analog In Config = .xx00
(P322) Analog In Hi = 10.0 V
(P323) Analog In Lo = 0.0 V