User Manual Instruction Manual

Starting Up the Drive Using the LCD OIM 9-1
CHAPTER 9
Starting Up the Drive Using the LCD OIM
For standard applications, the Start-Up routines on the LCD OIM enable you to
configure the most commonly used parameters through a series of steps. This helps
you set up the drive as quickly as possible.
For advanced applications, you may need to adjust additional parameters in the
parameter list using either the LCD OIM or V*S Utilities/ V*S Utilities Pro software.
9.1 Preparing for Start-Up
Before performing Start-Up, you must:
• be qualified to configure the drive and be familiar with the operation of AC drives.
• be familiar with the operation of the LCD OIM.
• have completed all hardware installation as described in chapters 2 through 7 of this
manual.
• properly connect the drive to the motor.
!
ATTENTION:Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards
involved should install, adjust, operate, or service this equipment.
Read and understand this chapter in its entirety before proceeding.
Failure to observe this precaution could result in severe bodily injury
or loss of life.
ATTENTION:When power is first applied to the OIM, it may require
approximately 4-5 seconds until any command is recognized,
including the “Stop” button. Failure to observe this precaution could
result in severe bodily injury or loss of life.
ATTENTION:Incorrect values for some of the parameters in the
Start-Up routines can cause the drive to operate improperly. Verify
that the values of these parameters are appropriate for your
application. Failure to observe this precaution could result in bodily
injury.