User Manual Instruction Manual

ManualsBrandsRockwell Automation ManualsEquipmentGV6000 AC Drive

111

112

113

114

115

116

117

118

119

120

Using the LCD OIM

8-9

Additionally, the most recently viewed process or status display screen becomes

active if no keys have been pressed before the display timeout period expires. See

section 8.5.3 for information about setting the display timeout period.

8.8.1 Displaying and Changing the OIM Reference

You can display the reference value that the OIM is sending to the drive by pressing

the up or down Chevron keys once when one of the process display screens is active.

See figure 8.6. The OIM reference can be used for the speed reference, PI reference,

or trim reference.

While the display is in Process Display Mode, the speed reference can be changed by

pressing and holding down either the up or down Chevron key until desired value is

displayed. Release the key to return to the process display screen.

Note that changing the value of the OIM reference does not affect the value of any

other port reference.

The value of the OIM reference is saved through a power cycle if Save OIM Ref (192)

is set to save at power down.

Figure 8.7 – Three Variable Process (User) Display Screen

Accelerating

52.3

MANF

19.4

401.2

Amps

Volt

User can scale

the output

values to suit

the application.

Up to three

process

variables can

be selected to

monitor.

Text can be

customized by

user.

Figure 8.8 – OIM Reference Displayed