User Manual Instruction Manual

Using the LCD OIM 8-7
8.7.1 Viewing and Adjusting Parameters
Refer to chapter 10 for information on how to access the parameters in the drive.
Each parameter screen contains the following information:
• Parameter Number
• Parameter Name
• Current parameter value and units
• Parameter range
To restore all parameters to their factory default values, select Reset Defaults from the
Memory Storage menu.
Figure 8.6 – Adjusting Parameters
Table 8.1 – How to Adjust Each Parameter Type
Parameter Type How to Adjust
Numbered List Use up/down arrow keys to advance through a list of options.
Bit Use SEL key to move the cursor to the bit location you want to
change. Use the up/down arrow keys to change the value of the bit.
Numeric Use the up/down arrow keys to increase/decrease the value.
OR
Use SEL key to move the cursor to the digit location you want to
change. Use the up/down arrow keys to change the value of the
digit.
Maximum Speed
SEL
LIMITS HELPVALUE
Parameter: # 082
RPM
1750.0
Maximum Speed
SEL
LIMITS HELPVALUE
Parameter: # 082
RPM
2150.0
Maximum Speed
SEL
LIMITS HELPVALUE
Parameter: # 082
RPM
1750.0
Step 2. Adjust the parameter
value using the UP/DOWN
arrow keys,and then press
ENTER to save the value.
If you do not want to save the
value, press ESC/PROG to
return to the initial parameter
screen. You can then repeat
steps 1 and 2 to change the
value, or press ESC/PROG to
back out of this menu.
Step 1: At the parameter entry
screen, press ENTER to
highlight the parameter value.