Operator Interface Module (OIM) User Guide

GV3000/SE OIM Menu and Parameter Organization
B-9
•
Draw & Trim Configure
• TRIM REF SOURCE (P.014)
• DRAW GAIN PERCENT (P.016)
• TRIM GAIN PERCENT (P.015)
•
S-CURVE ENABLE (P.019)
•
Jog Configure
• JOG SPEED REFERENCE (P.020)
• JOG RAMP ACCEL TIME (P.021)
• JOG RAMP DECEL TIME (P.022)
•
FRONT PNL SPD SCALING (P.028)
B.2.3 Application Setup (V/Hz)
•
CURRENT LIMIT (P.005)
•
LEVEL SENSE START ENABLE (P.054)
•
STOP TYPE (P.025)
•
TORQUE BOOST VOLTAGE (H.003)
•
AC LINE VOLTAGE (H.021)
•
DC Braking
• DC BRAKING ENABLE (H.005)
• DC BRAKING START FREQ (H.006)
• DC BRAKING CURRENT (H.007)
• DC BRAKING TIME (H.008)
•
VHZ-CURVE TYPE (H.018)
•
Avoidance Frequencies
• AVOID FREQ ENABLE (H.009)
• AVOID FREQ MIDPOINT 1 (H.010)
• AVOID FREQ BAND 1 (H.011)
• AVOID FREQ MIDPOINT 2 (H.012)
• AVOID FREQ BAND 2 (H.013)
• AVOID FREQ MIDPOINT 3 (H.014)
• AVOID FREQ BAND 3 (H.015)
•
LINE DIP RIDE THRU TM (P.042)
•
INPUT PWR/SNUB CONFIG (H.017)
•
CARRIER FREQ (KHZ) (P.047)
•
OVERFREQUENCY LIMIT (H.022)
•
Fault Functions
• MOTOR OVERLOAD ENABLE (P.040)