User guide

List of Tables

Table 2.1 – Jumper Selections for Digital Output Supply Source............................. 2-2

Table 2.2 – Relay Contacts ...................................................................................... 2-3

Table 2.3 – Analog Outputs...................................................................................... 2-3

Table 3.1 – Locating the Appropriate Installation Procedure ................................... 3-1

Table 3.2 – Model Numbers for 1 to 5HP@460VAC Drives.................................... 3-4

Table 3.3 – Model Numbers for 7.5 to 10 HP @ 460VAC Drives............................. 3-8

Table 3.4 – Model Numbers for 1 to 20HP@230VAC Drives................................ 3-12

Table 3.5 – Model Numbers for 30 to100 HP @ 230 VAC and

75 to 200HP @ 460VAC Drives ......................................................... 3-16

Table 3.6 – Model Numbers for 15 to 25HP and 25 to 60HP @ 460VAC Drives.. 3-21

Table 3.7 – Model Numbers for 200 to 400 HP @ 460VAC Drives........................ 3-31

Table 3.8 – Model Numbers for 2 to 43 Amp GV3000/SE Bookshelf Drives.......... 3-34

Table 3.9 – Wiring Signal and Control I/O to the RMI Board Terminal Strip .......... 3-42

Table 4.1 – Analog Output Source Selections for r.001, r.004, and r.007................ 4-2

Table 4.2 – Regulator Operating Modes................................................................... 4-4

Table 4.3 – Digital Input Configuration Selections for r.030 ..................................... 4-6

Table 4.4 – Preset Speed Digital Inputs ................................................................. 4-10

Table 4.5 – Digital Outputs and Relay Outputs Configuration Selections ............. 4-10

Table 5.1 – RMI Fault Codes ................................................................................... 5-1