Manualshelf

User guide

ManualsBrandsRockwell Automation ManualsEquipmentGV3000/SE, VTAC 7 Super Remote Meter Interface Board M/N 2SI3000 M/N 2SI3000E
51525354555657585960
4-2
Super Remote Meter Interface (RMI) Board
4.1 RMI Parameter Descriptions
Analog output 3 is jumper-selected between voltage or current signals (refer to
table 2.3). The default current range is 0 to 20mA. Further adjustments in current
offset and range can be programmed. For example, for a range of 4 to 20mA on
output 3:
r.008 (Offset) = +819 and r.009 (Gain) = 0.8
The data from the regulator to the analog outputs is normalized so that 4095
corresponds to positive full scale. Additional gain and offset calculation is done by the
RMI board. For outputs 1 and 3, the drive will take the absolute value of the data. The
value for output 2 may be signed (±4095).
r.001 to r.099 Analog Outputs
Par. Parameter Name Type Default Step Range
r.001 Analog Output 1 Source Config. 1 1 0 to 8 (Table 4.1)
r.002 Analog Output 1 Offset Tunable 0 1 –4095 to +4095
r.003 Analog Output 1 Gain Tunable 1.000 0.001 0.100 to 5.000
r.004 Analog Output 2 Source Config. 2 1 0 to 8 (Table 4.1)
r.005 Analog Output 2 Offset Tunable 0 1 –4095 to +4095
r.006 Analog Output 2 Gain Tunable 1.000 0.001 0.100 to 5.000
r.007 Analog Output 3 Source Config. 3 1 0 to 8 (Table 4.1)
r.008 Analog Output 3 Offset Tunable 0 1 –4095 to +4095
r.009 Analog Output 3 Gain Tunable 1.000 0.001 0.100 to 5.000
Table 4.1 – Analog Output Source Selections for r.001, r.004, and r.007
Analog Output Selection Scaling (Max. 4095) Update Filter
*
*
Filter outputs are suitable for metering purposes only.
0 = Not used Output = 0 100 ms none
1 = Motor Voltage Max. = H.000 x 1.1 (V/Hz)
U.007 x 1.1 (Vector)
100 ms 0.5 sec
2 = Motor Current Max. = H.002 x 1.5 (V/Hz)
U.004 x 1.5 (Vector)
5 ms none
3 = Speed Reference Max. = P.004 (V/Hz)
U.017 (Vector)
5 ms none
4 = Motor Speed or Frequency Max. = P.004 (V/Hz)
U.017 (Vector)
5 ms none
5 = Motor Torque Max. = 150% 100 ms 0.5 sec
6 = Motor Power kW Max. = H.000 x H.002 x 1.5 x 1.73 (V/Hz)
U.007 x U.004 x 1.5 x 1.73 (Vector)
100 ms 0.5 sec
7 = DC Bus Voltage Max. = 1.75 x panel volts 5 ms none
8 = PI Output Max. = Max. PI regulator output 100 ms none