Reference Manual User Manual

E-2
GV3000/SE AC Bookshelf Drive Software Reference, Version 6.06
Second Menu General Parameters (Continued)
❶
: Parameter default is Power Module-dependent
*See parameter description in chapter 4
Parameter
No. Parameter Name
USA
(P.049 = USA)
EUROPE
(P.049 = EUr)
JAPAN
(P.049 = JPn)
P.028 Speed Display Scaling P.048 = U-H
P.048 = UEC
*
U.017
*
U.017
*
U.017
P.029 Elapsed Time Meter Read only Read only Read only
P.030 Elapsed Time Meter Reset OFF OFF OFF
P.031 Preset Speed 1 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.032 Preset Speed 2 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.033 Preset Speed 3 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.034 Preset Speed 4 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.035 Preset Speed 5 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.036 Preset Speed 6 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.037 Preset Speed 7 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.038 Preset Speed 8 P.048 = U-H
P.048 = UEC
5.0 Hz
150 RPM
5.0 Hz
150 RPM
5.0 Hz
150 RPM
P.039 Encoder Loss Enable OFF OFF OFF
P.040 Motor Overload Enable ON ON ON
P.041 Motor Overload Type FC FC FC
P.042 Line Dip Ride-Through Time 5.0 5.0 5.0
P.043 Fault Auto Reset Attempts 0 0 0
P.044 Fault Auto Reset Time 8 8 8
P.045 Output Phase Loss Enable ON ON ON
P.047 Carrier Frequency (kHz)
❶ ❶❶
P.048 V/Hz or Vector Regulation U-H U-H U-H
P.049 Country Defaults USA EUr JPn
P.050 Restore Defaults OFF OFF OFF
P.051 Programming Disable 0 0 0
P.052 AUTO/MAN Key Disable OFF ON OFF
P.053 Manual Reference Preset Enable OFF OFF OFF
P.054 Level Sense Start Enable OFF OFF OFF
P.055 STOP/RESET Key Disable OFF OFF OFF
P.060 Network Drop Number 1 1 1
P.061 Network Connection Type 0 1 0
P.062 Option Port: Communication Loss Response 0 0 0